New LED lamp rates highly in hybrid lighting trial

Functional design offers other benefits besides efficient grow light
236 0
New LED lamp rates highly in hybrid lighting trial

A trial with hybrid lighting (SON-T + LED) at Dutch tomato nursery Gebroeders Koot has yielded good results. The LED lamp used in the trial, which was developed on British soil with Dutch input, offers several advantages. One stand-out benefit is its clever design which makes it easy to integrate into existing SON-T installations.

Yields up by more than nine percent after seven months (weeks 48-26). That was the auspicious outcome of a greenhouse trial at Prominent growers Gebroeders Koot in Poeldijk, the Netherlands, where a tomato crop grown under 150 μmol/m2/sec SON-T grow light was compared with an identical crop supplemented with 58 μmol deep red with a little blue LED light. Geert Koot, who had had no previous experience in growing under grow light, was very impressed. “I hadn’t expected the higher light level to make such a difference,” he says. “That will appeal to a lot of growers. The same goes for the lamp itself, which has a surprisingly simple design. It’s fully interchangeable with SON-T, so it fits seamlessly into an existing system.”
“A lot of thought has gone into the functional design,” cultivation specialist Maarten Klein adds. He and his assistant, Tim Valstar, oversaw the trial, which was run on behalf of the British LED manufacturer Plessey. Klein, who has had a lot of experience with grow light, developed this lamp in collaboration with the technology company.

Smarter design

“Most LED systems are difficult if not impossible to integrate into existing lighting installations,” Klein continues. “Growers looking to switch to hybrid lighting currently have to install a whole new system alongside their existing one, often with extra C profiles. That pushes up the cost and results in more light interception, which causes problems all year round. Plessey Semiconductors in Plymouth wanted to eliminate these problems.”
To test the practical value of the lamp in the greenhouse setting, Klein approached several Dutch nurseries. In addition to Gebroeders Koot, trial setups were installed at nearby alstroemeria and gerbera growers and a pot plant nursery.

Trial setup

Although Gebroeders Koot were not growing tomatoes under artificial lighting, they did have a SON-T system in place in a section that had previously been let to another grower. These 1000W lamps supplied 151 μmol/m2/s extra grow light and, of course, the usual radiated heat. LED lamps were added in one bay, ramping up the artificial light level to 209 μmol.
Tim Valstar assisted with the trial and, together with Geert Koot, took measurements in the trial and reference sections. All the relevant crop and fruit features of the variety grown, Brioso, were recorded, varying from growth rate and stem thickness to leaf size, leaf colour, fruit weight and Brix value.

Results

The plants arrived in the greenhouse in week 46. “That’s later than the usual for an artificially lit Brioso crop – they would usually go in in mid-October – but the lighting period was long enough to get a reliable impression of any differences,” Koot says. “The plants developed well in both light environments. But the plants under the higher light level were that little bit stronger with slightly thicker stems and more dark green leaves.”
Due to the extra vigour, the plants under the hybrid lighting regime held the first trusses for longer and they were harvested a few days later than those in the reference sections. The higher yield potential quickly expressed itself in a higher average fruit weight. To maintain the desired fineness, one fruit more was kept on the truss (11 instead of 10) from the tenth truss onwards, without the plants forfeiting vigour.
Valstar: “After week 26 we stopped taking measurements and were able to take stock.” The harvest under the hybrid lighting regime was 38.32 kg per m2 compared with 35.04 kg under SON-T. That represents an increase in yield of 9.35%. The average fruit weight was also slightly higher than under SON-T, at 39.2 grams compared with 38.8 grams.

Flexible use

The attractive increase in yield can’t be ascribed solely to the higher light levels in the periods when both systems were in use. The SON-T system was switched off and the CHP unit shut down for maintenance at the beginning of week 19, whereas the LED system was used from 4 am to 7 am for a further three weeks.
“The option to only use the LED lamps either end of the lighting season would be an extra benefit,” Klein says. “Those are often the times when you don’t need the radiated heat produced by the SON-T lamps. LEDs have virtually no impact on the climate. You can always switch them on if you need more grow light. And because they are much more energy-efficient than SON-T lamps, you also have more flexibility when it comes to deciding whether to generate the energy yourself with CHP.”

375 and 600W

Klein is keen to point out that the prototype trialled at Gebroeders Koot was developed exclusively for research purposes. But the lamp has since undergone further development and a commercial 375W version was launched at IPM 2017. All the LEDs are now in one bay and the fitting, which has integrated cooling ribs, can be attached directly to the trellis.
The lamp is called Hyperion 1000 because it has a photon flux of 1000 μmol/s. “Because of the higher uptake of deep red light, it’s the equivalent of a 600W SON-T lamp but it uses 40 percent less electricity,” the cultivation specialist says. “The producer has also recently brought out a more powerful 600W version which is the equivalent of a 1000W SON-T lamp.”

Ten years ago

There is a lot of added value in the new lamp, Koot believes. “It’s efficient, it has a broad spectrum, and its clever design makes it easy to incorporate into an existing system. That will appeal to a lot of growers. I’m also quite impressed. But because of my age and the fact that I have no successor in place, I have decided not to invest in any more grow lights now. If this trial had taken place ten years ago, I would almost certainly have gone for them. But we very much enjoyed taking part in the trial.”

Summary

A new type of LED lamp produced in the UK is achieving interesting results. The clever design makes the lamp particularly attractive. It can be attached to the trellis without the use of C profiles and can be integrated into existing 600W SON-T systems with standard connectors. A more powerful version equivalent to a 1000W SON-T lamp was brought out earlier this year.

Text and images: Jan van Staalduinen.

Leave a reply

Your email address will not be published.